Coats ProRide Wheel Balancer User Manual download pdf (Page 19)

Important: Always read and follow instructions. • 15

Standard Front Cone Mounting

A wheel should be centered by the outer side of the

hub only when the inner surface will not provide an

accurate surface to center on.

Figure 8 - Front Cone Mounting

1. Select the cone that best fits the center hole in

the wheel.

2. Lift the wheel onto the shaft and slide it back

against the shaft faceplate.

3. Slide the cone onto the shaft and into the center of

the wheel. You will need to lift the tire to seat the cone

in the center hole.

4. Install the hub nut (without pressure cup) onto the

shaft. Tighten it securely against the cone. The hub nut

must engage the threads for at least four full turns.

Note: If the hub nut will not tighten completely

because of a lack of threads, use an additional cone as

a spacer between the mounting cone and the hub nut.

The wheel must be forced firmly against the faceplate.

Alternate Mounting

If the wheel has a protruding outer hub which will not

permit the use of the pressure cup, or the cup will not

permit the hub nut to engage at least four turns of the

shaft, this alternate method should be used.

1. Select the cone that best fits the center hole in the

wheel. Slide the cone onto the shaft with the large end

towards the faceplate.

2. Lift the wheel onto the shaft and center it on the

cone.

3. Use the small nylon spacer (no-mar ring) or a

centering cone to press against the outer wheel hub.

4. Install the hub nut (without the pressure cup) onto

the shaft. Tighten securely.

Figure 9 - Alternate Mounting

Pneumatic Shaft (PL Version Only)

Use the most appropriate mounting method for the

wheel, but instead of using a hubnut use the pneumatic

sleeve. When the pneumatic sleeve is in place, press

down on the positioning pedal to mount the wheel on

the shaft.

Figure 10 - Pneumatic Mounting

Important: Always be sure to remove the wheel

assembly from the pneumatic shaft before disconnect-

ing the air supply from the machine.

Shaft

Cone

Hub Nut

Face Plate

Shaft

Cone

Hub Nut

No-Mar

Ring

Face Plate

Faceplate

Cone

No-Mar

Ring

Pneumatic

Sleeve

Pressure

Cup

Rubber Lip

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 33 34

Comments to this Manuals

No comments

Coats ProRide Wheel Balancer User Manual Page 19

Comments to this Manuals

Related products and manuals for Equipment Coats ProRide Wheel Balancer