Coats ProRide Wheel Balancer User Manual download pdf (Page 17)

Important: Always read and follow instructions. • 13

Balancing Set-up Screen

The balancing set-up screen provides you with many

possibilities for presetting the machine according to

your requirements. These settings remain unaltered

even when the machine is switched off.

Buttons enabled:

Return to previous window

Stop & Exit

Return to Result screen

Display Options

Under display options the following buttons are enabled:

➤ Display Units

Select whether to display the out of balance values

in grams, ounces or both.

➤ Static Imbalance Displayed

Enable/disable Static on Screen™ display. You can

always select the static frame by pressing the button

from the result screen.

➤ Calculation Roundoff

Scroll through to set a weight correction roundoff

value. Typically you would set it around 0.25 ounces

(7 g) for most wheels and around 0.50 ounce (14 g)

for heavy wheels.

➤ Lower Weight Limit

The out of balance threshold below which - - -,

instead of the out of balance value, appears on the

screen at the end of a measurement cycle. Note that

the closer you set the lower limit to 0.13 ounces (4

g) the more respins you will have when attaching a

0.25 ounce (7 g) weight.

Runout Options

Under runout options the following buttons are enabled:

➤ Radial Runout Displayed

The radial runout value display on the main screen.

➤ Runout Diagnosis

Enable/disable automatic runout diagnosis screen at

the end of spin.

➤ Runout Measuring Unit

Select whether to display runout values in mm or

inches.

➤ Max True Runout Limit

Set a desired tolerance that indicates the limit of

runout allowed on the tire/wheel before it is suitable

to match balance.

➤ Rim Runout Limit

Set a desired tolerance that indicates the limit of

runout allowed on the rim before it is suitable to

match balance.

➤ Correction Runout Limit

Set the minimum correction limit tolerance obtain-

able below which it is not considered appropriate to

match balance.

Light Truck Mode

The default is OFF. Scroll to set a value of 1", 1.5" or 2".

This is only necessary if a tire/wheel assembly requires

an adjustment to the automatic width measurement

value, where the actual tire width value is greater than

(extends beyond) the actual rim width value.

Offset Arm Locking

Enable/disable distance gauge locking when the correct

distance is reached to apply the adhesive weight to cor-

rect the out of balance. To release the offset arm, lower

it to below 10-inch diameter.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 33 34

Comments to this Manuals

No comments

Coats ProRide Wheel Balancer User Manual Page 17

Comments to this Manuals

Related products and manuals for Equipment Coats ProRide Wheel Balancer