Coats ProRide Wheel Balancer User Manual download pdf (Page 25)

Important: Always read and follow instructions. • 21

LASER ON: to split the out of balance measured in

two different positions, proceed as follows:

Position the static out of balance or outboard adhesive

weight in the correction position and press button

1. Turn the wheel and press the button when

the laser points to the spoke where the correction is to

be made.

2. Release the button.

3. Turn the wheel in the direction indicated on the dis-

play until the second spoke is in the position indicated

by the laser and press the

button.

4. At this point, two indications are shown on the

screen to position the spokes for the out of balance

correction.

5. Move the spokes indicated to the correction posi-

tion and correct according to the value displayed.

Important: Always follow the information provided by

the wheel to optimize correction.

Note: When SPLIT is enabled, the icon appears

on the left of the screen.

Indicate Exact Corrective Weight Position

It is recommended that you always use this function

to correct an out of balance using adhesive weights.

Remember to thoroughly clean the application areas.

Figure 21 - Indicate Exact Corrective Weight Position Screen

LASER OFF: press button on results screen.

Pull out the arm to position 1 as shown in figure 14

page 16:

1. Place a Tape-A-Weight™ onto arm.

2. Rotate assembly until the correction position is

reached, indicated by:

3. Pull arm out until aligns with and

the arm locks into position.

4. Rotate the arm to the correction position and apply

the Tape-A-Weight™ onto the wheel.

Note: When the acoustic signal is enabled, reaching a

fixed arrow is accompanied by a BEEP.

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 33 34

No comments

Coats ProRide Wheel Balancer User Manual Page 25