Coats Hood Installation Tip User Manual download pdf

Hood Installation Tip

Instruction

COATS, Inc. • Hennessy Industries • P.O. Box 3002, 1601 J.P. Hennessy Drive, LaVergne, TN 37086-1982

(800) 688-6359 • (615) 641-7533 • (615) 641-5104 FAX

Mechanical Hood Switches Can Be

Damaged During Installation

Balancers are now equipped with mechanical

hood switches.

These switches can be damaged by the

switch actuator rod during installation if you are

not careful.

To help avoid damage during installation, the

balancer is shipped with Styrofoam separating

the switches.

When the hood is installed, it is very impor-

tant that the switch actuator rod contact the

Styrofoam at the middle of the slot and stay at

that position as the hood tube is pushed in.

As the hood tube is pushed in, the actuator

rod must push the Styrofoam in. Be sure the

Styrofoam is clear. If not, use a small screw-

driver to push it in and out of the way.

If the balancer fails to operate, it may be

because one of the switches was damaged

during hood installation or the Styrofoam has

not cleared the switches.

CAUTION

Mechanical

Hood Switches

Styrofoam Separating

Hood Switches

Switch Actuator Rod

must Contact Styrofoam

at Center of Slot

Hood Switch

Actuator Rod

Hood Installation TipInstructionCOATS, Inc. • Hennessy Industries • P.O. Box 3002, 1601 J.P. Hennessy Drive, LaVergne, TN 37086-1982(800) 688-6359 •

No comments

Coats Hood Installation Tip User Manual