Coats 6450 3D User Manual download pdf (Page 7)

Important: Always read and follow the information box instructions. • 1

ÌBalancing Your First Tire

1. Turn the machine OFF then

ON (resets machine).

| Note: The machine wakes up using standard clip-

on wheel weight locations (Clip 1 & Clip 2) and

wheel dimensions.

2. Mount a tire/wheel on the bal-

ancer that will use standard

clip-on wheel weights.

Use the most appropriate mounting method.

3. Always remove any weights

already attached to the wheel.

4. Enter A & D wheel dimen-

sions using offset arm.

For Automatic Measurement — pull offset arm out

to the wheel, hold it still at clip-on weight position

against wheel flange, and wait for BEEP. Return

arm to home position.

Clip-on Weight Location — viewed on a cut-away

rim for clarification.

Figure 1 - Clip-On Weight Location

Note the value entry of A & D dimension.

5. Enter Width wheel dimension.

For Manual Entry — Use plastic calipers to mea-

sure wheel width. Press W key. Use keypad to

enter Width value (between 2.0 and 20.0 inches).

For Automatic Measurement — Lower hood.

Note value entry of W dimension.

6. Lower the hood; wheel spins

and unbalances are measured

and displayed.

The corrective weight amount appears in the

weight display window for inboard and outboard

weight locations.

7. Raise hood after tire stops

rotating.

Note: Wait for wheel to stop before raising the

hood.

8. Inboard center bar blinks.

Note: If an inboard corrective weight is not

required, the wheel will stop at the outboard cor-

rective weight location, go to step 11.

9. Attach inboard corrective

weight.

Attach specified weight amount at top-dead-cen-

ter on inside flange of wheel.

10. Press NEXT; wheel rotates.

11. Outboard center bar blinks.

12. Attach outboard corrective

weight.

Attach specified weight amount at top-dead-cen-

ter on outside flange of wheel.

13. Lower the hood to respin the

tire/wheel and check balance.

The weight readings should now be 0.00.

Note: Throughout this manual tire dimensions are

referred to as A, W, and D, see figure 2.

Figure 2 - A, W, and D Tire Dimensions

1 2 3 4 5 6 7 8 9 10 11 12 ... 27 28

Comments to this Manuals

No comments

Coats 6450 3D User Manual Page 7

Comments to this Manuals

Related products and manuals for Equipment Coats 6450 3D