Coats 6401 Computer Truck Wheel Balancer User Manual download pdf (Page 9)

COATS 6401 Truck Wheel Balancer • 3

Installation and Setup

A factory trained COATS

Service Technician must perform the

install, setup, and initial test procedures on your 6401 balancer.

Do not attempt to install and setup the unit yourself. Accurate

and reliable operation of your unit depends on proper installa-

tion. Please contact COATS

directly at 1-800-688-9240 for the

Certified Service Partner nearest you.

Floor and Space Requirements

The balancer must be located on a flat floor of solid construc-

tion, preferably concrete. The balancer must sit solidly on its

three feet. If the balancer is not level, does not sit solidly on its

three feet, or is placed on an unstable floor, the balancer will not

function properly and will produce inaccurate balance readings.

Do not operate the balancer when it is still bolted down or

while it is on the pallet.

Select a location for the balancer that provides a level, solid

floor, and adequate clearance around and above the balancer

(Figure 1). Make sure the location selected has enough room

above and behind the unit so the hood can be raised completely.

The location must also provide working room for mounting and

removing wheels.

Direct Drive

Figure 1 - Space Requirements

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 23 24

No comments

Coats 6401 Computer Truck Wheel Balancer User Manual Page 9