Coats 6065 A/E/AX/EX Tire Changer User Manual

1601 J. P. Hennessy Drive, LaVergne, TN USA 37086-3565 615/641-7533 800/688-6359 Manual Part No.: 8183540 00HENNESSY INDUSTRIES INC. Manufactur

T. If tire and wheel are properly lubricated andoperator cannot achieve bead seal after 3 or 4attempts, the valve core may be removed from thevalve st

Figure 18 - Location of Manual Release ValvePerformance, Custom, and AluminiumWheelsOnly tire technicians withexperience and trainingon custom wheels

AD: Wheels with an asymmetrical hump have alarger "ledge" type hump around the wheelexcept at the valve hole making them moredifficult to mo

Figure 28 - Insert Bead Lifting Tool (Optional Drop CenterTools Shown)9. Hold lifting tool in place and depress the tabletop control pedal momentarily

4. Mount the top bead using short rotations of thewheel. On stiff sidewall tires, add a second dropcenter tool to keep the bead in the drop center.Fig

Stages of InflationReview these descriptions and diagrams carefully.Refer to them as necessary during bead sealing,bead seating, and inflation to veri

Maintenance InstructionsRead and follow all the maintenance instructionsprovided in this manual to keep the machine in goodoperating condition. Refer

Separator/Lubricator MaintenanceCheck oil and water levels regularly, and performthese maintenance items weekly:A. Disconnect air supply to machine.B.

Installation InstructionsProper unit installation isnecessary for safe useand efficient operation.Proper installation also helps protect the unitfrom

COATS 6065A/AX/EX Rim Clamp Tire Changer • 17

Table of ContentsDefinitions of Hazard Levels ...1Owner’s Responsibility ...1Princi

8183540 01/98 © Copyright 1998, 2001 Hennessy Industries and COATS®All Rights Reserved Printed in USAFAILURE TO READ AND FOLLOW ALL WARN-INGS AND INS

Definitions of Hazard LevelsIdentify the hazard levels used in this manual withthe following definitions and signal words:DANGERWatch for this symbol:

Principal Operating PartsTower — Support for horizontal and verticalslides, also air storage tank.Air Inflation Gauge — Registers tire pressurewhen cl

Operating InstructionsThe unit must be properly operated and properlymaintained to help avoid accidents that coulddamage the unit and injure the opera

5. Determine the mounting side of the wheel. Themounting side is the narrow side of the dropcenter. (Tire removed in Figure 4 for clarity.)Figure 4 –

10. Insert the smooth curved end of the bead liftingtool over the forward end of the demount headand below the top bead of the tire. Use your freehand

MountingThis information must be read and followed carefullyto prevent accidents and injuries during mounting.Check tire and wheelcarefully before mou

INFLATIONTire inflation is performed in three steps: bead seal,bead seat, and inflation. These steps are explainedin detail on page 13. Read the expla